Expobar 증기 보일러

The boiler’s fit into the group assembly was spot-on, and the threading felt solid right out of the box. It’s been holding steam pressure steadily since I swapped it in, so my shots have been consistent. Took a few minutes to install, but that’s the part doing its job properly.

Installed this in my old espresso machine and it fit perfectly, no modification needed. The brass fittings feel solid and the steam pressure is finally back to where it should be.

The steam boiler arrived well-packaged and the threading matched up cleanly with my existing group assembly. Took about an hour to swap out, and I'm glad it's a genuine part rather than a gamble on a knockoff. Only gripe is there's no gasket included, so have one ready before you start.